Drawing Up The Bobbin Thread; Balancing The Thread Tension - ELNA 3003 Instruction Manual

DRAWING UP THE BOBBIN THREAD
Raise the presser foot and hold the needle thread
Q007) Press the up/down needle position key 3003 + 3005):
Turn the balance wheel Pull bath threads to the leh and
lrghrly w~th your left hand.
'Wrce towards you until the needle has risen and the
under the presser foot, leaving
take-up lever is at its highest position.
10 cm (4")
Lightly draw up the needle thread forming a loop
of the bobbin thread
BALANCING THE THREAD TENSION
In straight seams, the needle thread Turn the thread tension dial until the
Loosen the needle thread tension by Tighten the needle thread tension
Adjusting the Thread Tension for
and the bobbin thread should inter-
desired number is facing the setting moving the dial to a lower number
by turning the dial to a higher
Z'ftgz and Embroidery.
lock in the center of the two layers mark
number.
The upper thread tension should be
of fabric.
slightly weaker when sewing a zig-
zag or a pattern based on the satin
stitch. The upper thread should
appear slightly on the reverse side
of the fabric.