Actual Values Mode; Starts/Hour Timer; Time Between Starts Timer; Table : 3-2 269P Lus Actual Values - GE 269Plus Instruction Manual

3 SETUP AND USE
In ACTUAL VALUES mode, any of the parameters monitored or calculated by the 269Plus may be viewed by
the user. This mode is divided into seven separate pages of data, each of which contains a different group of
actual motor values. The contents of these pages are shown in the table below:
Table 3–2: 269Plus ACTUAL VALUES (Sheet 1 of 9)
PAGE LINE INFORMATION LINE
ACTUAL VALUES PAGE 1: PHASE CURRENT DATA
1 1
PAGE 1: ACTUAL VALUES
PHASE CURRENT DATA
1 2
MOTOR STARTING
###1###2###3###4###5###6
1 3
I1= XXXX
I3= XXXX
1 4
I(3 ph avg) = XXXX AMPS
Max Stator RTD = XXX C
I(3 ph avg) = XXXX AMPS
T.C. USED = XXX PERCENT
1 5
UNBALANCE RATIO (In/Ip)
U/B = XXX PERCENT
1 6
GROUND FAULT CURRENT
G/F = XX.X AMPS
1 7
ST/HR TIMERS (MIN)
XX
1 8
TIME BETWEEN STARTS
TIMER = XX MIN
1 9
III III III III
III III
III III
1 10
END OF PAGE ONE
ACTUAL VALUES
† Available only if a meter is online.
‡ Messages not shown if the answer to
GE Power Management
Courtesy of NationalSwitchgear.com
I2= XXXX
(AMPS) ---
XX XX XX XX
1 III III III III 2 III III III III 3 III III III III 4 III III III III 5 III III III III
III III III III III III III III III III
1 III III 2 III III 3 III III 4 III III 5 III III
A R E T H E R E A N Y R T D S C O N N E C T E D ?
269Plus Motor Management Relay
DESCRIPTION
ACTUAL VALUES page 1 header.
Motor starting current level (seen only during a
motor start).
Motor phase current data.
( becomes when motor is running.)
- - - R U N
If Actual Values page 1, line 2 is set to be displayed,
it will only show when the motor is starting, then
default to this line. Programming the line the display
defaults to is done in Setpoints page 5.
Average of 3 phase currents. Thermal capacity
used. This line is shown only if the answer to the
question
A R E T H E R E A N Y R T D S C O N N E C T E D ?
Average of 3 phase currents. Thermal capacity
used. This line is shown only if the answer to the
question
A R E T H E R E A N Y R T D S C O N N E C T E D ?
Ratio of negative to positive sequence currents.
Actual ground fault current
Starts/hours timers; see Section 3.4a) STARTS/
HOUR TIMER on page 3–15.
Time between starts timer; see Section 3.4a)
STARTS/HOUR TIMER on page 3–15.
This line can be examined to ensure that all pixels in
6
the 40 character display are functional.
6
Last line of page 1.
is (located on Setpoints page 2, line 3).
N O

ACTUAL VALUES MODE

3.4 ACTUAL VALUES MODE
is .
N O
is
N O
3
3-
7