Procedure - FLIR E96-24-42 User Manual

7 Handling the camera
Note
• The laser is enabled by a setting. Select
ser > Enable lamp & laser.
• The symbol is displayed on the screen when the laser is on.
• The camera can be configured to automatically measure the distance when an image
is saved. Select (Settings) > Save options & storage > Measure distance. With
this setting, the Object distance parameter (see section 13.5 Changing the measure-
ment parameters) in the image data is automatically updated with the measured dis-
tance when an image is saved. (There is no effect on the Object distance setting in
live mode.)
• If the target reflection is low or if the target is angled from the laser beam, there may
be no return signal, and the distance cannot be measured.
• The laser distance meter is not supported by all camera models.
• The laser distance meter may not be enabled in all markets.

7.5.2 Procedure

To operate the laser, do the following:
1. To turn on the laser, push and hold the laser button
displayed on the screen.
2. To turn off the laser, release the laser button
#T810587; r. AD/90967/90989; en-US
(Settings) > Device settings > Lamp & la-
. The distance to the target is
.
30