Backlighting Brightness; Code Modification; Enter New Code - APRILIA PEGASO 650 STRADA Service Station Manual

Electrical system
•
RUN-IN REVOLUTIONS: 5000 rpm
•
MINIMUM REVOLUTIONS: 4000 rpm
•
MAXIMUM REVOLUTIONS: 8000 rpm
If the set threshold value is exceeded, the alarm
warning light on the instrument panel starts to
flash. It turns off when the value goes back below
the threshold limit.

Backlighting brightness

This function adjusts the backlighting brightness to
three levels. Each time the MODE selector is
pressed to the right or left, the following icons are
shown:
•
LOW
•
MEAN
•
HIGH
Once the operation is finished, when the MODE
selector is pressed at central position, the instru-
ment panel shows the SETTINGS menu.

Code modification

This function is used when the old CODE needs to
be changed; in this case the old code should be
available, or rather the instrument panel must be
started with one of the programmed key. The fol-
lowing message is first displayed: Enter the old
code. After the old code is recognised, the new
code is requested with the following message:

Enter new code

Once the operation is finished, the instrument pan-
el goes back to the DIAGNOSIS menu.
If the user has used the code, this operation is not
allowed.
Once the operation is finished, the instrument pan-
el goes back to the SETTINGS menu.
This function is used when the old CODE is not
available and it needs to be changed. In this case,
two programmed keys will have to be inserted.
ELE SYS - 42
PEGASO 650 STRADA - TRAIL - FACTORY