Rmon Collection Rmon1 - Digisol DG-GS4528SE Management Manual

rmon collection rmon1

show running-config
this index is not available for the port to which is normally assigned.
For example, if control entry 15 is assigned to port 5 as shown below,
the show running-config command will indicate that this entry is not
available for port 8.
Console(config)#interface ethernet 1/5
Console(config-if)#rmon collection history controlEntry 15
Console(config-if)#end
Console#show running-config
!
interface ethernet 1/5
rmon collection history controlEntry 15 buckets 50 interval 1800
...
interface ethernet 1/8
no rmon collection history controlEntry 15
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#rmon collection history controlentry 21 owner mike buckets
24 interval 60
Console(config-if)#
This command enables the collection of statistics on a physical interface.
Use the no form to disable statistics collection.
S
YNTAX
rmon collection rmon1 controlEntry index [owner name]
no rmon collection rmon1 controlEntry index
index – Index to this entry. (Range: 1-65535)
name – Name of the person who created this entry.
(Range: 1-127 characters)
D S
EFAULT ETTING
Enabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
C U
OMMAND SAGE
By default, each index number equates to a port on the switch, but can
u
be changed to any number not currently in use.
If statistics collection is already enabled on an interface, the entry must
u
be deleted before any changes can be made with this command.
The information collected for each entry includes:
u
input octets, packets, broadcast packets, multicast packets, undersize
packets, oversize packets, fragments, jabbers, CRC alignment errors,
collisions, drop events, and packets of specified lengths
– 799 –
| Remote Monitoring Commands
C 24
HAPTER
command will display a message indicating that