Displaying Details For Local Meps - Digisol DG-GS4528SE Management Manual

D D
ISPLAYING ETAILS
L MEP
FOR OCAL S
Use the Administration > CFM > Show Information (Show Local MEP
Details) page to show detailed CFM information about a local MEP in the
continuity check database.
CLI R
EFERENCES
"show ethernet cfm maintenance-points local detail mep" on page 1294
u
P
ARAMETERS
These parameters are displayed:
MD Index – Domain index. (Range: 1-65535)
u
MA Index – MA identifier. (Range: 1-2147483647)
u
MEP ID – Maintenance end point identifier. (Range: 1-8191)
u
MD Name – The maintenance domain for this entry.
u
MA Name – Maintenance association to which this remote MEP
u
belongs.
MA Name Format – The format of the Maintenance Association name,
u
including primary VID, character string, unsigned Integer 16, or
RFC 2865 VPN ID.
Level – Maintenance level of the local maintenance point.
u
Direction – The direction in which the MEP faces on the Bridge port (up
u
or down).
Interface – The port to which this MEP is attached.
u
CC Status – Shows if the MEP will generate CCM messages.
u
MAC Address – MAC address of the local maintenance point. (If a CCM
u
for the specified remote MEP has never been received or the local MEP
record times out, the address will be set to the initial value of all Fs.)
Defect Condition – Shows the defect detected on the MEP.
u
Received RDI – Receive status of remote defect indication (RDI)
u
messages on the MEP.
AIS Status – Shows if MEPs within the specified MA are enabled to
u
send frames with AIS information following detection of defect
conditions.
AIS Period – The interval at which AIS information is sent.
u
AIS Transmit Level – The maintenance level at which AIS information
u
will be sent for the specified MEP.
– 525 –
| Basic Administration Protocols
C 14
HAPTER
Connectivity Fault Management