Specifying Passive Interfaces - Digisol DG-GS4528SE Management Manual

Figure 411: Showing Network Interfaces Using RIP
Use the Routing Protocol > RIP > Passive Interface (Add) page to stop RIP
S P
PECIFYING ASSIVE
from sending routing updates on the specified interface.
I
NTERFACES
CLI R
u
C
u
u
P
These parameters are displayed:
u
W
To specify a passive RIP interface:
1.
2.
3.
4.
EFERENCES
"passive-interface" on page 1400
U
OMMAND SAGE
Network interfaces can be configured to stop RIP broadcast and
multicast messages from being sent. If the sending of routing updates
is blocked on an interface, the attached subnet will still continue to be
advertised to other interfaces, and updates from other routers on the
specified interface will continue to be received and processed.
This feature can be used in conjunction with the static neighbor feature
(described in the next section) to control the routing updates sent to
specific neighbors.
ARAMETERS
VLAN – VLAN interface on which to stop sending RIP updates.
(Range: 1-4093)
I
EB NTERFACE
Click Routing Protocol, RIP, Passive Interface.
Select Add from the Action list.
Add the interface on which to stop sending RIP updates.
Click Apply.
– 667 –
C 19
HAPTER
Configuring the Routing Information Protocol
| Unicast Routing