Specifying Snmp Trap Receivers; Figure 30: Snmp Settings - Digisol DG-GS1526 User Manual

S SNMP T
PECIFYING
Click Apply.
6.

Figure 30: SNMP Settings

R
RAP ECEIVERS
Traps indicating status changes are issued by the switch to specified trap
managers. You must specify trap managers so that key events are reported
by this switch to your management station (using network management
software).
P
ARAMETERS
The following parameters are displayed on the SNMP Setting page for trap
receiver configuration:
IP Address – IP address of a new management station to receive
◆
notification messages.
Community String – Specifies a valid community string for the new
◆
trap manager entry. The string must already be defined in the
Community String Setting section. (Range: 1-32 characters, case
sensitive)
W I
EB NTERFACE
To configure SNMP system settings:
Click Configuration, SNMP Setting.
1.
– 93 –
| SNMP Settings
C 13
HAPTER

Specifying SNMP Trap Receivers