Vdwall LVP615U User Manual page 34

LVP615U 使用说明
6.2.2 Hot spare setting
LVP615U supports hot spare of input signals. When the current
input signal is lost. LVP615U will switch to the spare signal
automatically to avoid image interruption caused by the fault of signal
source.
As shown in the above table，if "2.2 V1/V2 backup
signal is lost, processor will switch to V2 automatically.
6.2.3 V2 or YPbPr selection
V2 and YPbPr of LVP615U share the same port and button. Need
configure. Default input is V2. If need YPbPr input, then need set this
2.1custom DVI EDID
--------------------------------------
2.1.1 Cus. width
2.1.2 Cus. height
2.1.3 Cus. V Freq.
2.1.4 Apply
2.Input video signal
--------------------------------------
2.1 DVI EDID
2.2 V1/V2 backup
2.3 VGA1/VGA2 backup
2.4 HDMI/DVI backup
2.5 V2 or YPbPr
2.6 switch mode
34
1920
1002
60
OK to apply
1280x1024_60
off
off
off
V2
one key switch
on", if V1