Vdwall LVP615U User Manual page 26

LVP615U 使用说明
Normally it's less than 1 second. Sometimes it's necessary to
perform several times until the output image is clear, full and stable.
5.4.3 Full/ part display（Bypass）
In signal switching status, press Bypass
and part display.
This function only works when current signal is PC input signal
（VGA1/ VGA2/ DVI /HDMI /DP). Fixed other signals to Full mode.
state
Full
Part
Note:When the width and height of input image are lower than the
LED screen real width or height value. Part display is invalid.
5.4.4 Text overlay
LVP615U allows for overlapping text, logo or flash on the current
image. The operation is as below.
When the current input display properly, enter setup
menu"3.Text overlay" ， set "3.1text overlay" on ， then select text
source.Text can be produced by PowerPoint and other office software.
description
Full display,the input image is compressed and fully
displayed on the led screen and the indicator is off.
Part display, the input image is not compressed.Only a
part of it can be displayed on the screen and the indicator
is on.
26
button to switch full