To send an assigned
group of extensions
(except priority,
intercom, and personal
central office calls)
immediately to an
assigned extension,
AUDIX, or message
center for coverage
To cancel Send All Calls
or SAC Group
Speaker
Note: Your voice terminal is set for either the Speaker (listen-only) or the
Speakerphone (listen and talk) function. Check with your system manager to see
which of these two features you can use.
You can use the Reset Speakerphone feature only if your voice terminal is set for
Speakerphone (listen and talk).
In order for the other party to hear you, you must speak through the handset.
Use the following procedures if your voice terminal is set for the Speaker
(listen-only) feature.
To place a call without
lifting the handset, or to
use speaker with any
listening-only feature
activity (such as,
monitoring a call on
which you have been put
on hold or for group
listening)
1 While on-hook or off-hook, press [
1 While off-hook, press [
again
or Lift handset and dial Send All Calls
cancel code
Your calls ring at your own voice terminal again
1
Press [
]
Speaker
Red light next to [
to [
] goes on
Mute
2
Place call or access selected feature
3
Adjust speaker volume if necessary
To raise the volume, press the right half of the
Speaker Volume control button labeled [
to lower the volume, press the left half of the
Speaker Volume control button labeled [
SAC Group
[confirmation tone]
] or [
Send All Calls
[confirmation tone]
] goes on; red light next
Speaker
∧
∨
]
]
SAC Group
] ;
]
34