Edit Name - Konica Minolta CM-700d Instruction Manual

2
Use the button of the cross key to move the
cursor to "OK" and press the [SAVE/SEL]
button. Data will be deleted.
M
emo
When data is deleted, the subsequent sample data Nos. will be
reassigned, reducing them by one.
• When the deletion is complete, the screen returns to the
<Menu> screen.
• When you place the cursor on "Cancel" and press the
[SAVE/SEL] button, the deletion is canceled and the screen
returns to the <Menu> screen.

Edit Name

Name the measured data.
[Setting Procedure]
1
Use the or
the cursor to "Edit Name" and then press the
[SAVE/SEL] button.
The <Edit Name> screen is displayed.
M
emo
The initial value for the name is "No Name".
2
Use the or
the cursor, and use the
change the letter.
• Use the button of the cross key to move the cursor
backward to correct letters.
• Pressing the [SAMPLE] (Clear) button clears all letters.
• Up to 16 characters can be used.
• The available letters are upper/lower-case alphabets, symbols, numbers (0 to 9), and a space.
Available symbols
! "
, -
[ ¥
3
When you finish entering letters, press the [SAVE/SEL] button.
The name is confirmed, and the screen returns to the <Menu> screen.
N
ote
If you press the [TARGET] (Back) button without pressing the [SAVE/SEL] button, you return to the
sample data screen without changing the name.
Start the procedure from the <Menu> screen of the <Sample> screen.
button of the cross key to move
button of the cross key to move
or button to
# $ %
. / :
] ^ _
Measured Data Operation
& ' (
; < =
' { |
) * +
> ? @
}
E-83