Setting The Measurement Conditions - Konica Minolta CM-700d Instruction Manual

Condition Setting

Setting the Measurement Conditions

To set measurement conditions, select "Meas. Cond." from the <Option> screen.
You can select or specify the following four items as the measurement conditions:
• Mode: Select the specular component mode.
• Wait Time: Specify the delay between the press of the measuring button and the flash of the lamp.
• Auto Ave.: Specify the number of measurements for auto averaging.
• Manual Ave.: Specify the number of measurements for manual averaging.
[Setting Procedure]
1
Hold down the [MENU] button and press the
button of the cross key.
The <Option> screen is displayed.
2
Use the or
move the cursor to "Meas. Cond." and then
press the [SAVE/SEL] button.
The <Meas. Cond.> screen is displayed.
N
ote
When setting of "Cond" is "ON" (refer to page E-56),
"Disp. Cond" and "Meas. Cond" cannot be selected.
• The <Meas. Cond.> screen shows the current settings.
3
After you set the measurement conditions, press the [TARGET] (Back) button to
return to the <Option> screen.
E-42
button of the cross key to