Web Interface - Cisco CTS-SX10-K9 Getting Started Manual

Cisco TelePresence SX10 Quick Set
SX10 Quick Set

Web interface

You have to use the remote control for the configurations,
until you know your system's IP address.
Find the IP address
Navigate to the upper left corner on the home screen and
press OK on the remote control. Then navigate to
and press OK. Here you can find the IPv4 address and/or
IPv6 address of the system.
Signing in to the web interface
1. Open a web browser and enter the system's IP address
in the address bar.
2. Enter your user name and password and click
The default user name is admin with no password set.
If you are not able to connect to the system:
• Make sure the system and computer are connected to
the same network.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes
to allow the system to start up.
Back to task overview
D15117.01 SX10 Getting Started Guide TC7.1, MAY 2014.
Contents Introduction
Settings
Sign In.
Configuration Configuration
The web interface
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
11
Getting Started Guide
Appendices Contact