Setting The Date, Time And Location - Cisco CTS-SX10-K9 Getting Started Manual

Cisco TelePresence SX10 Quick Set
SX10 Quick Set

Setting the date, time and location

(When not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among
other things this information is used to time stamp messages
transmitted to gatekeepers and other network elements.
The time and date is shown in the top right corner of the main
display.
If you are changing a value setting,
you have to always click save to confirm the change.
Back to task overview
D15117.01 SX10 Getting Started Guide TC7.1, MAY 2014.
Contents Introduction
1. Go to the Configuration
Configuration.
Open the Time
2. Select your preferred date format in the
down list.
3. Select your preferred time format in the
down list.
4. Select your time zone in the
5. Open the NetworkServices
6. Under the NTP
Mode drop down list.*
If you select
Address input field.
* NTP mode:
Auto: The time is regularly updated using an NTP server. The NTP server
address is automatically obtained from the network (DHCP).
Manual: The time is regularly updated using an NTP server. You must
manually enter the NTP server address.
Off: Not available for SX10 TC7.1 version.
Configuration Configuration
tab and select System
settings from the left column.
DateFormat drop
TimeFormat
Zone drop down list.
settings from the left column
section select Auto or Manual in the
Manual, enter the NTP server address in the
15
Appendices
drop
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contact