Sip Configuration - Cisco CTS-SX10-K9 Getting Started Manual

Cisco TelePresence SX10 Quick Set
SX10 Quick Set

SIP configuration

(When not set by a provisioning system)
To get online and ready to place and receive calls, your
system must be set up properly. Your system uses SIP
protocol for video calls.
NOTE: Contact your system administrator, or service provider,
for information about the network settings.
You can find information about administering through Cisco
UCM in the Administering TC endpoints on CUCM
The diagnostics on your system will indicate if there is a
problem with the SIP registering.
If you are changing a value setting,
you have to always click save to confirm the change.
Back to task overview
D15117.01 SX10 Getting Started Guide TC7.1, MAY 2014.
Contents Introduction
SIP
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Go to the Configuration
System Configuration.
2. Open the SIP
guide.
3. Under the Profile 1
URI 1 input field, and optionally a display name in the
DisplayName
Select the preferred transport protocol from the
DefaultTransport
system first tries to connect using Tls, then TCP, and
finally UDP.
4. Select a proxy type in the
default type is Standard.
5. Go to the Proxy 1
If you want the system to obtain the SIP proxy address
automatically, select
if you want to enter the address manually, select Manual.
If you select Manual, enter the proxy
corresponding input field.
6. If the SIP proxy requires authentication, you must enter
a login name and password to authenticate your system.
Go to the Authentication 1
LoginName
fields.
7. Click the Home
verify the SIP settings.
If you have successfully registered to a SIP server, the
Status is shown as
If you wish to change the other SIP settings, check the
administrator guide for your product.
Configuration Configuration
tab, and select
page from the left sidebar.
heading, enter the SIP URI in the
input field.
drop down list. If you select Auto, the
Type drop down list. The
subheading.
Auto in the Discovery drop down list;
Address in the
subheading and enter the
and Password in the corresponding input
tab to see the System Information and
Registered in the SIP section.
14
Getting Started Guide
Appendices
www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved.
Contact