Installing The Uid Health Module; Verifying Uid Health Module Operation; Replacing The Enclosure Backplane; Before You Begin - HP storevirtual 3200 User Manual

10. Slide the UID health module (2) out of the enclosure while guiding the cable through the enclosure.
CAUTION:
The UID cable is firmly adhered to the chassis. Care should be take to peel the UID cable carefully
off the enclosure chassis.

Installing the UID health module

Procedure
1. Install the replacement UID health module by sliding the cable through the slot in the enclosure.
2. Reconnect the UID health module cable to the backplane.
3. Adhere the UID health module to the chassis.
4. Fasten the UID health module using the retaining screw.
5. Install the enclosure cover and press the hood latch down to engage the latch.
6. Install the enclosure in the rack.
7. Tighten the front retaining screws.
8. Install fan module 2. See Installing a fan module on page 62.
9. Reconnect all cables to the enclosure, including the power cables.

Verifying UID health module operation

Procedure
1. When the enclosure has completed its power on sequence, check all enclosure status LEDs to ensure the
enclosure is operating properly. For more information, see Status LED descriptions on page 15.

Replacing the enclosure backplane

Before you begin

The procedure should be performed only if Hewlett Packard Enterprise Support has determined that the
enclosure backplane has failed and must be replaced.
Installing the UID health module 65