Storing Pulse-Tronic Charge; Storing Supply/Diagnostic Mode - Projecta HDBM4000 Instruction Manual

END OF CHARGE – EXAMPLE
CHARGE COMBINATION CHART
Battery Type (T)
AUTO
AUTO i
WET, GEL, AGM, PdCa
2.2.2 CHARGE FUNCTION MODES
It is possible to store the last function modes, so they are immediately available
after any switching ON/OFF.

2.2.2.1 STORING PULSE-TRONIC CHARGE

Storage of voltage and type of battery, charge mode.
Procedure:
– Check that the charge clamps are not connected to a battery;
– Connect the power cable to the mains socket;
– Set the desired charge mode;
– Disconnect the power cable from the mains socket.

2.2.2.2 STORING SUPPLY/DIAGNOSTIC MODE

Storage of delivered voltage and current.
Procedure:
– Set the chosen mode and adjust the voltage/current values as required;
– Turn on the lock settings by pressing, at the same time, both keys
"BATTERY VOLTAGE" (fig.A.21) and "CHARGE RATE"(fig.A.23) for
3 seconds, on the display (fig.A.2)(fig.A. 4) will appear "LOK on."
14
Battery Current (C)
Auto
Auto Boost
Manual 'Ah'
Auto
Auto Boost
Manual 'Ah'
Auto
Auto Boost
Manual 'Ah'