Projecta HDBM4000 Instruction Manual page 5

AUTO/MANUAL ADJUSTABLE OUTPUT
Manually or use the Automatic charge setting feature to adjust the rate of charge to
best suit different battery sizes.
MULTI VOLTAGE OPERATION
Suitable for charging 6V, 12V & 24V batteries.
SHORT CIRCUIT & POLARITY PROTECTION
POWER SUPPLY MODE
Supply Power to the vehicle whilst the battery is being changed.
DIAGNOSTICS POWER SUPPLY
Supplies stabilised power to the vehicles MCU whilst receiving software updates.
BATTERY CHEMISTRY SELECTION
The Multi-Chem function allows you to set the charging profile to suit each battery's
chemistry type (GEL, AGM, WET and Calcium). This ensures correct and thorough
charging and maximises battery performance and battery life. The following section
describes the charge profiles for each chemistry type.
MANUALY SET EQUALISATION
Manually configure an Equalisation routine to balance all the cells of the battery.
MANUALY SET DESULPHATION
Manually perform Desulphation on the battery.
BATTERY AND ALTERNATOR TESTING
Test Battery Voltage.
Performs a check on the Alternator.
Checks the battery while starting.
SILENT MODE
The charger can run with the fan turned off where it is important for the charger to
be running silent, like a car show room.
OPTIONAL 6 & 10 METRE LEADS
Optional 6 or 10 metre battery leads can be purchased for applications where longer
leads are required.
5