Step 4 - Set Charge Rate - Projecta IC2500L User Manual

STEP 2 – REMOTE CONTROL OPTIONAL & TEMPERATURE SENSOR
Connect the temperature sensor prior to turning on the charger this is required for
lithium charging to maximize life and performance of the battery. If you require the
remote control this is optional and must be fitted prior to turning on the power.
To install the remote control, insert the data plug into the data socket at the rear of the
battery charger.
Cable length: 4.5 metres.
Warning: Ensure the cable is secured safely away from moving parts.
Installing Temperature Sensor
To install the temperature sensor, insert the plug into the temperature sensor socket at
the rear of the battery charger. Install the ring terminal to the negative battery terminal.
Cable length: 1.8 metres
Warning: Ensure the cable is secured safely away from moving parts.
STEP 3 – CONNECT TO 240V MAINS POWER
Connect the battery charger to the 240V mains powered socket and turn on the mains
power. Turn battery charger On/Off switch to on.
STEP 4 – SET CHARGE RATE
The charge rate should be set according to the size of the battery. See the recommended
charge rates for various battery sizes in the table below.
(Not all ouputs are available on all models)
a. Press the CHARGE RATE button. The LCD screen will flash the present setting.
b. Press the CHARGE RATE button repeatedly until desired setting is displayed.
c. Wait for the LCD screen to stop flashing.
Note: Failure to wait for the screen to stop flashing will cause the charge rate to default
to previous setting.
ADJUSTABLE CHARGE RATES: 12 VOLT BATTERIES
Current setting
2A
6A
12A
25A
50A
12
AH
C-2 C-10
4 20
12 60
24 120
50 250
50 500
Time
2 – 10h
2 – 10h
2 – 10h
2 – 10h
2 – 10h