Projecta HDBM4000 Instruction Manual page 24

Customising VOLTAGE and CURRENT
VOLTAGE
FUNCTION SELECTION
– press and hold simultaneously the "BATTERY VOLTAGE" (fig.A.21) and "MODE" FUNCTION SELECTION
MODE
buttons (fig. A.22) for 3 seconds
MODE
– use the same buttons to select (decrease using the "BATTERY VOLTAGE" button
and increase using the "MODE" button) the desired voltage value between
6V-7.5V, 12V-15V, 24V-30V respectively for 6V, 12V, 24V batteries; the factory
default voltage value is respectively 6.8V, 13.6V,27.2V.
The set voltage mode will be exited automatically after a 3" time-out.
VOLTAGE ADJUSTMENT – EXAMPLE
VOLTAGE ADJUSTMENT – EXAMPLE
BATTERY VOLTAGE
BATTERY VOLTAGE
DISPLAY
DISPLAY
CURRENT
– press the "CHARGE RATE" button until the desired value, set as indicated in
step 6, appears on the display (fig. A .4) and on the icon (fig. A.6). The set
current mode will be exited automatically after a 3" timeout.
CURRENT ADJUSTMENT – EXAMPLE
CURRENT ADJUSTMENT – EXAMPLE
CHARGE
RATE
CHARGE
RATE
3A 7A 10A 20A 30A 40A
3A 7A 10A 20A 30A 40A
CHANGE BATTERY Procedure
– Press the "MODE" button (fig. A.22) to select the SUPPLY function (fig. A.12);
– if necessary or requested by the vehicle manufacturer specifications, customise
the voltage and/or current values as indicated above;
– press the "BATTERY VOLTAGE" button (fig. A.21) to select the battery voltage
(fig. A.1);
– connect the clamps to the relative vehicle battery terminals;
– change the battery paying particular attention not to disconnect the clamps from
the vehicle terminals so as not to lose the electronic settings.
24
DISPLAY
DISPLAY
MODE
MODE
3
BEEP
3
BEEP
13.3V
13.2V
13.1V
13.3V
. . . . .
13.2V
13.1V
. . . . .
►
►
3A 7A 10A 20A 30A 40A
3A 7A 10A 20A 30A 40A
. . . . .
13.7V
. . . . .
13.6V
13.5V
13.7V
13.6V
13.5V