Projecta HDBM4000 Instruction Manual page 13

c) CUSTOMISED PULSE-TRONIC
It is possible to select:
– the battery construction technology (fig. A.11)choosing between:"WET, GEL,
AGM, PbCa"
– the charge current (fig.A.6) choosing between:"AUTO" - automatic setting
according to battery conditions;"BOOST" - rapid charge;
– the Ah - customised setting of the battery Ah (fig.A.2) using 6 predefined
values selected using the "CHARGE RATE" button (fig. A.23), adjustable
at 5 Ah intervals using the "BATTERY VOLTAGE" button (fig. A.21),
and"MODE" (fig. A.22).
Ah SETTING – EXAMPLE
CHARGE
RATE
15Ah 100Ah
BATTERY VOLTAGE
DISPLAY
Charge Rate Amps
END OF CHARGE – EXAMPLE
3
7
10
20
30
40
Note. The final charge voltage depends on the technology of construction of the
battery; to avoid damaging the battery, pay special attention to the technical
specifications given by the manufacturer.
The PULSE TRONIC charge process (fig. A.17) starts when the display stops flashing,
each individual phase is identified on the display (fig.A.14) and terminates with
the message (fig. A.2) "OK". The battery charge status is displayed graphically in
(fig. A.5). If the charge process is not successful, an alarm message appears on the
display (fig. A.2) (see alarms list). When the battery is charged, the battery charger
switches automatically to maintenance mode.
►
300Ah
15Ah 100Ah
MODE
80Ah
75Ah
70Ah
. . . . .
Amp hours
15
70
100
200
300
600
300Ah
. . . . .
100Ah
95Ah
90Ah
CCA
90
420
600
1200
1800
3600
13