Install & Log On The Rccs - EMS firecell Setup Manual

2 Install & Log On the RCCs
POWER
FAULT
SYSTEM
FAULT
FIRE
Fire Alarm Control
The Radio Cluster Communicators (RCCs) require installing in their proposed
locations. Refer to the Radio Cluster Communicator Installation Guide (TSD053) for
more information.
A unique ident number is shown on the side of each RCC. This should be noted as
this is required when logging on (adding the RCC to the Radio Hub).
From Front Display
Path * Select Desired Loop & Device Address
12345 Y? 'Enter the RCCs ident
To Exit
BACK
* = If the RCCs signal path is to be direct to the Radio Hub, then Radio Hub should
be selected. If the RCC's signal path is via another RCC, then the relevant RCC will
need to be selected. Each option can be chosen by turning the rotary control.
230V AC
Hub/RCC Options
New Addr L1 A002.
POWER
FAULT
230V AC
POWER
FAULT
230V AC
Add RCC
4
POWER
FAULT
Select Desired Signal
Add By Ident
230V AC
Add Dev