Cut-Out Mark Dimensions - Cembre ROLLY 2000 Operation And Maintenance Manual

26 7 Media
7.4

Cut-out mark dimensions

for marginal cut-out marks minimum liner thickness 0,06 mm
Fig. 21 Cut-out mark dimensions
Dim. Designation
A Label distance
N Width of cut-out mark
P Height of cut-out mark
X Distance mark - material edge
Y Sensor recognised virtual label front edge with gap sensor
Z Distance recognised front edge - actual label front edge
 Adjust software settings
Table 11 Cut-out mark dimensions
Marginal cut-out
Fig. 26 Samples for cut-out marks
Labels with cut-out marks
for marginal cut-out
Long hole cut-out
Continuous material with cut-out marks
Rectangular cut-out Circular cut-out
Not recommended !
Dim. in mm
> 2
> 5
> 8
2 - 10
5 - 53
Rear edge cut-out
0 up to A-P
Cut-out
between the labels
Not recommended !