Using The Printer; Power-On Utilities; Gap/Black Mark Sensor Calibration Utility - Cembre Rolly 1000 Operation And Maintenance Manual

Thermal transfer printer

Hide thumbs Also See for Rolly 1000:

Table of Contents

4. USING THE PRINTER

There are two power-on utilities to calibrate sensors and initialise the printer hardware.

These utilities are activated by pressing the PAUSE button, PAUSE and FEED buttons

and turning on the printer power simultaneously. The utilities are:

1. Gap/black mark sensor calibration

2. Printer initialisation

This utility is used to calibrate the sensitivity of the gap/black mark sensor. The

gap/black mark sensor must be calibrated whenever changing the label media,

executing printer initialization, or the message "NO PAPER" appears in the

display, even when material is present.

Calibrate the sensor by following one of the procedures:

- Verify that the sensor is correctly positioned (refer to section 3.3.1)

Procedure A, using the power on off switch.

1. Install the ribbon and media (refer to sections 3.2 and 3.3) and engage the print

head lift lever.

2. Turn off printer power.

3. Press PAUSE then power up the printer. Release the PAUSE key when

"GAP/BLINE sensor calibrating...." message is shown on the LCD display.

The printer will calibrate the Gap / Black mark sensor automatically.

Procedure B, using the Control buttons.

1. Install the ribbon and media (refer to sections 3.2 and 3.3) and engage the print

head lift lever.

2. Turn on the printer.

3. The 'MENU' button twince; message 'Sensor calib' displayed.

4. The 'PAUSE' button once; message 'Auto gap' displayed.

5. The 'PAUSE' button once; printer will operate and the sensor will calibrate.

6. The 'MENU' button six times; message 'Exit' displayed.

7. The 'PAUSE' button once; message 'Sensor calib' displayed.

8. The 'MENU' button four times; message 'Exit' displayed.

9. The 'PAUSE' button once; message 'Ready' displayed.

Table of Contents