Unpacking And Setting-Up The Printer; Connecting The Device; Connecting To The Power Supply; Connecting To A Computer Or Computer Network - Cembre ROLLY 2000 Operation And Maintenance Manual

8 2 Installation
2.2

Unpacking and setting-up the printer

 Lift the label printer out of the box via the straps.
 Check label printer for damage which may have occurred during transport.
 Place the printer on a level surface.
 Check delivery for completeness.
Contents of delivery:
• Label printer
• USB cable
• Power cable
• Black printer ribbon type TPS-060 842112 already fitted into the printer
• Protective cover
• Operating software on "GENIUSPRO" CD
• Documentation
Notice!
i
Please keep the original packaging in case the printer needs to be returned or transported.
Attention!
!
The device and printing materials will be damaged by moisture.
 Set up label printers only in dry locations protected from splash water.
2.3

Connecting the device

The standard available interfaces and connectors are shown in figure 3.
2.3.1

Connecting to the power supply

The printer is equipped with a power unit suitable for supply voltages 230 V~ / 50 Hz or 115 V~ / 60 Hz without
adjustment.
Check that the device is switched off.
1. Plug the power cable into the power connection socket (6).
2. Plug the power cable into an earthed socket.
2.3.2

Connecting to a computer or computer Network

Attention!
!
Inadequate or no earthing can cause malfunctions during operations.
Ensure that all computers and cables connected to the label printer are grounded.
 Connect the label printer to a computer or network an appropriate cable.
2.4

Powering up the device

When all connections have been made:
 Switch the printer on at the power switch (23).
The printer performs a system test, and then shows
the system status ready in the display (11).
If an error occurs during the system test, the symbol
and type of error are displayed.
Fig. 4 Power-on
23