Positioning The Label Roll On The Roll Retainer; Inserting A Label Strip Into The Printhead - Cembre ROLLY 2000 Operation And Maintenance Manual

4 Loading material
4.1.2

Positioning the label roll on the roll retainer

Attention!
!
To guarantee good condition of the labels it is suggested to keep the rolls in their original packing at a
normal, even temperature; do not touch the underside of the print head with fingers or pointed objects.
 Remove labels from the packing only when used and do not expose the materials to humidity for a
long period.
9
8
7
6
Fig. 10 Loading labels from roll
1. Open cover (9).
2. Turn ring (2) at the margin stop (1) counterclockwise, so that the arrow points to the symbol
the margin stop.
3. Remove the margin stop (1) from the roll retainer (4).
4. Load label roll (3) on the core adapters ( 4.1.1 on page 12) in such a way that the labels can be inserted into the
printhead in the right position. The printing side of the labels must be visible from above.
5. Re-mount the margin stop (1) onto the roll retainer (4). Push the margin stop (1) to the roll until it stops.
6. Turn ring (2) clockwise, so that the arrow (10) points to the symbol
retainer (4).
4.1.3

Inserting a label strip into the printhead

1. Turn lever (8) counterclockwise to lift the printhead.
2. Push red guide ring on to axle (6) all the way out.
3. Guide label strips below the axle (6) and through the label sensor (7) in such a way that it exits the print
unit between the printhead and the print roller.
4. Push guide ring on to axle (6) against the outer edge of the label strip.
, and thus release
, and thus fix the margin stop (1) on the roll
13
1
2
3
4