Table of Contents
Advertisement
3.3 Loading
Media reels
1. Locate the 3" hub on the media spindle and mount a reel of media (fig. 8).
2. Pull the media leading edge under the media guide bar, ensuring it passes
through the green Gap / Black mark sensor and is against the black stop on left
side (figs. 9a & 9b), then under the Print head, until it protrudes from the machine.
3. Adjust the clamp to restrict sideways movement of the media and close it to the
bar, ensuring the media can advance freely by pulling it from the front.
Figure 7. Media reel installation
Figure 6.
Ribbon & Media installation path
Label roll
3" adaptor
Media guide bar
10
Figure 7a.
Gap/Black mark sensor
Gap/Black mark sensor
Advertisement
Table of Contents
