Connectors - Icom IC-7300 Basic Manual

8
SET MODE

Connectors

ACC/USB Output Select
Selects the signal output from [ACC] and [USB].
ACC/USB AF Output Le el
Sets the AF output level of [ACC] and [USB].
ACC/USB AF SQL
and [USB], according to the squelch state.
The same audio signals are output from [USB] and
[ACC].
ACC/USB AF Beep/Speech... Output (Default OFF)
Sets the Beep and Speech audio output condition of
[ACC] and [USB].
Limit" item is "ON."
ACC/USB IF Output Le el
Sets the IF output level of [ACC] and [USB].
ACC MOD Le el
Sets the modulation input level of [ACC].
USB MOD Le el
Sets the modulation input level of [USB].
DATA OFF MOD
Selects the connector(s) to input the modulation signal
DATA MOD
Selects the connector(s) to input the modulation signal
External Keypad VOICE
Enables voice memory transmission using an external
keypad.
External Keypad KEYER
Enables keyer memory transmission using an external
keypad.
External Keypad RTTY
Enables RTTY memory transmission using an
external keypad.
(Default AF)
(Default OFF (OPEN))
(Default MIC,ACC)
(Default ACC)
(Default OFF)
(Default OFF)
(Default OFF)
CI-V Baud Rate
Selects the CI-V data transfer rate.
When "Auto" is selected, the baud rate is
automatically set according to the data rate of the
connected controller.
CI-V Address
Selects the CI-V address.
CI-V Transcei e
Turns the Transceive function ON or OFF.
Sets the address used to remotely control the
transceiver or receiver using the optional RS-BA1,
through the [USB] port.
The external equipment control signal is output from
the [REMOTE] port.
CI-V Output (for ANT)
Enables outputting the antenna controller status
(frequency and so on) from the [REMOTE] port.
CI-V USB Port
[USB] and [REMOTE] CI-V ports.
CI-V USB Baud Rate
When "Auto" is selected, the baud rate is
automatically set according to the data rate of
external controller.
item is set to "Unlink from [REMOTE]."
CI-V USB Echo Bac
CI-V port.
item is set to "Unlink from [REMOTE]."
USB Serial Function
Selects the signal output from [USB].
8-5
(Default Auto)
(Default ON)
(Default OFF)
(Default Link to [REMOTE])
(Default Auto)
[USB] CI-V port.
(Default OFF)
(Default CI-V)