Icom IC-7300 Basic Manual page 34

4
RECEIVING AND TRANSMITTING
mode, and you can select them on the FILTER screen.
narrow (FIL 3).
1. Select the operating mode.
2. Touch the filter icon for 1 second.
•
3. Touch the filter icon more times to select FIL 1
(wide), FIL 2 (mid) or FIL 3 (narrow).
4.
• Selects the passband width mode.
5. Rotate MAIN DIAL to select the passband width.
You cannot change the passband width in the FM or
FM-D mode.
setting value is reset to the center position.
Passband width mode
Displayed when a band width less than 500 H
6.
• Cancels the passband width mode.
7. Repeat steps 2 to 6 to set the passband width for
other modes except for the FM and FM-D.
8. To close the FILTER screen, push
TIP
mode, the transceiver will transmit in the FM narrow mode.
CW
RTTY
AM
AM-D
FM
FM-D
operating modes to soft or sharp.
1.
2. Touch the filter icon for 1 second.
Touch for 1
3. Touch the filter icon several times to select FIL1
second to reset
to default.
4. Touch [SHARP] or [SOFT].
5. To close the FILTER screen, push
.
EXIT
4-4
FIL 1 3.0 kH )
50H to 500H (50 H )
FIL 2 2.4 kH )
600H to 3.6kH (100 H )
FIL 3 1.8 kH )
FIL 1 1.2 kH )
50H to 500H (50 H )
FIL 2 500 H )
600H to 3.6kH (100 H )
FIL 3 250 H )
FIL 1 2.4 kH )
50H to 500H (50 H )
FIL 2 500 H )
600H to 2.7kH (100 H )
FIL 3 250 H )
FIL 1 .0 kH )
FIL 2 6.0 kH ) 200H to 10.0kH (200 H )
FIL 3 3.0 kH )
FIL 1 15 kH )
FIL 2 10 kH ) Fixed
FIL 3 7.0 kH )
• Opens the FILTER screen.
(wide), FIL2 (mid) or FIL3 (narrow).
When [SOFT] is selected
EXIT .