How To Set The Unit - ACME CHEETAH LED-GF50 User Manual

of the touch of people and has no one pass by or under it.

4. How To Set The Unit

4.1 Control Panel
1. Display: To show the various menus and the selected functions
2. Button
MENU To select the programming functions
DOWN To go backward in the selected functions
UP To go forward in the selected functions
ENTER To confirm the selected functions
3. LED
DMX On
MASTER On
SLAVE On
SOUND Flashing
4. Only for remote control
By connect to the 1/4'' microphone jack (CA-8) or 5-pin (CA-9) to control the unit for Stand
by, Function and Mode function.
5. DMX input
For DMX512 link, use 3-pin XLR plug cable to link the unit together.
6. DMX output
For DMX512 link, use 3-pin XLR plug cable to link the unit together.
7. Mains input
IEC socket and integrated fuse holder, connect to main power cable.
DMX input present
Master Mode
Slave Mode
Sound activation
4-
8. Power output
Connect to supply power for the next unit.
9. Safe ring
Keep the installation safe.
10. Microphone: Receive music for the sound active.
4.2 Replace the lens
You could replace the other lens if you want to, as following picture.
You should screw the lens roller to take it down as NO.1, and bring the lens out as No.2.
Then you could replace the lens that you want to.
4.3 Main Function
To select any of the given functions, press the MENU button up to when the required one
is showing on the display. Select the function by ENTER button and the display will blink.
Use DOWN and UP button to change the mode. Once the required mode has been
selected, press the ENTER button to setup or it will automatically return to the main
functions without any change after idling 60 seconds. To go back to the functions without
any change press the MENU button. The main functions are showing below:
5-