Safety Instruction; Technical Specification; Installation - ACME CHEETAH LED-GF50 User Manual

1. Safety Instruction

Please read the instruction carefully which including
important information about the installation, operation and
WARNING
— Please keep this User Manual for future consultation. If you sell the unit to another
user, be sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before using the unit.
—
— Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric
—
shock.
The unit is for indoor use only and use only in a dry location.
—
The unit must be installed in a location with adequate ventilation, at least 50cm from
—
adjacent surfaces. Be sure that no ventilation slots are blocked.
Disconnect mains power before fuse replacement or servicing.
—
Replace fuse only with the same type.
—
— Make sure there are not flammable materials close to the unit while operating as it is
fire hazard.
Use safety cable when fixes this unit.
—
— Maximum ambient temperature is TA: 40 ℃ and don't operate it where the
temperature is higher than this.
Unit surface temperature may reach up to 60℃. Don't touch the housing bare-hand
—
during its operation.
There are no user serviceable parts inside the fixture. Do not open the housing or
—
attempt any repairs by yourself. In the unlikely event your fixture may require service,
please contact the nearest authorized technical assistance center and always use the
same type spare parts. .
Don't connect the device to any dimmer pack or power pack.
—
— Do not look directly at the LED light beam while the fixture is on.
The housing must be replaced if they are visibly damaged.
—
Do not touch any wire during operation as high voltage might be causing electric
—
shock.
maintenance.
2-
If using a 230Vac 50Hz power supply, do not connect in series
more than 7 units, use another mains supply for the next 7 units.
If using a 120Vac 60Hz power supply, do not connect in series
more than 4 units, use another mains supply for next 4 units.

2. Technical Specification

— It can be operated by DMX512 control or can be used as an individual unit without
controller.
Please use a 3 pin XLR cable/plug when link in master/slave mode.
—
— LED: 50W white LED
Voltage: AC 100~240V, 50Hz/60Hz
—
Fuse: T 6.3 A
—
— Power Consumption: 89.2 W
Dimension: 283 x 377 x 218 mm
—
Weight: 5.2kgs
—

3. Installation

The unit should be mounted via its screw holes on the bracket. Always ensure that the unit
is firmly fixed to avoid vibration and slipping while operating. Always ensure that the
structure to which you are attaching the unit is secure and is able to support a weight of 10
times of the unit's weight. Also always use a safety cable that can hold 12 times of the
weight of the unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out
3-