Auto Show; Static Color; Sound Mode; Manual Color - ProLights TRIBE TRUSSPOD3T User Manual

8

3.4 AUTO SHOW

This fixture has a built-in automatic program. To access this, please see the below instructions:
• Press the button MENU so many times until shows [P--], then press the button ENTER.
• Using UP/DOWN button, select one of the programs [P1 - P4].
• Press the button ENTER to confirm.
• Press the button MENU until [S--] appears on the display.
• Use the button UP/DOWN to select the auto programs speed [S001 - S100] (slow-fast).
• Press the button ENTER save the setting.

3.5 STATIC COLOR

This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MENU so many times until shows [C--], then press the button ENTER.
• Using UP/DOWN button, select one of the programs [C1 - C7].
• Press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.6 SOUND MODE

• Press the button MENU so many times until the display shows [Snd].
• Using UP/DOWN button, select one of the modes [Snd1] or [Snd2].
• You can set the microphone sensitivity pressing the button MENU so many times until the display show
[Sens]
• Using the button UP/DOWN, select the desired value sensitivity (slow-fast) [u0 - u100].
• Press the button ENTER to confirm.

3.7 MANUAL COLOR

This mode allows to combine the colors red, green, blue amber white and purple (r, g, b).
• Press the button MENU so many times until the display shows [U--], then press the button ENTER.
• Select the color [r, g, b] through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Using UP/DOWN button, select the desired color value [000 - 255].
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.8 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 11).
• Use any one of the standalone modes for the master unit.
• Set the slaves to the same DMX modes.
TRUSSPOD3T