Bayer HealthCare Bai An Jie 2 User Manual page 14

R C
UNNING A ONTROL
There are times when you will want to do a quality control
test so you know that your system is working properly.
You may also want to do a control test to check the way
you do your test. Simply follow these steps:
Push Out Test Strip
1. Hold the meter comfortably in
one hand. Firmly grasp the meter
handle with the other hand
(shown here). Now, just "Pull
and Push"—"Pull" the handle
out until it stops and "Push" it
back in until it stops again.
NOTE:
After the meter handle is pushed in, the release
button is UP, a test strip is pushed out and a series of
"apply blood" prompts appears. The meter is now ready
to run a control test.
2. Squeeze a small drop of
(Bai An Jie ) control
solution onto a nonabsorbent
surface (such as a clean piece
of wax paper). Do not apply
control solution to the test strip
directly from the bottle.
NOTE:
The control solution contains a red dye and may stain.
22
Bayer Customer Service: (852) 8100 6386
T :
EST
Test
3. Move the entire front edge of
the test strip until it touches
the edge of the drop of the
control solution. The control
solution is automatically
pulled into the test strip.
IMPORTANT:
Hold the test
strip in place until the meter
beeps, then move the meter away.
4. After the beep, the display
counts down from "5" to "1."
Your control test result then
appears on the screen.
www.bayerdiabetes.com
23