Fujitsu AOU48RLXFZ Design & Technical Manual page 205

FUNCTION SETTING
1) After verifying that the system is normally, press the MODE/EXIT button (SW931) once.
LED961 LED962
2) Press the SELECT button (SW932), and display "F2" on the LED962.
(Monitoring mode)
LED961 LED962
*1
(The display of the LED962 changes each time when the SELECT button is pressed.)
*1:The "F1"and "F9" modes are used for maintenance, so do not set them in regular operation.
3) When "F2" appears on the LED962, press the ENTER button (SW933).
A flashing display appears on the LED961, and the flashing display of "F2" on the LED962
changes to the illuminated display of a number.
LED961 LED962
4) Referring to the Settings List shown below, press the SELECT button (SW932) and display the
code number of the mode you want to set on the LED961.
Ex.) To select switching between Forced Stop and Emergency Stop
LED961 LED962
Next, press the ENTER button (SW933), and confirm the selection of the mode you want to
set.
A flashing display on the LED961 changes to an illuminated display, and an illuminated display
on the LED962 changes to a flashing display.
LED961 LED962
LED961 LED962
(Setting mode) (Function mode)
LED961 LED962
LED961 LED962
LED961 LED962
LED961 LED962
- (06 - 51) -
(Error history mode)
LED961 LED962
6. SYSTEM DESIGN
LED961 LED962
*1