Fujitsu AOU48RLXFZ Design & Technical Manual page 127

INSTALLATION
1) Remove the insulation of the remote controller cable.
55 (2-5/32)
45 (1-25/32)
30 (1-3/16)
8 (5/16)
8 (5/16)
8
(5/16)
2) Insert the flat-blade screwdriver and remove the front case and rear case by twisting it
slightly.
Hooks (2 places)
Flat screwdriver
3) Install the rear case to the wall, box, etc. with 2 screws (M4 × 16 mm). Fix the 2 screws in
either horizontal or vertical position.
A. When mounting on the box:
● Attach the case after leading the cable.
Remote controller cable
Box
Rear case
● When connecting the remote controller cable, take measures to prevent the water or insects
coming into the remote controller through the cable, such as to provide the trap or close the
hole for cabling with the putty.
4) Setting up the DIP switch. Refer to "6. SYSTEM DESIGN".
Unit : mm (in.)
1. 12V (Red)
2. Signal (White)
3. COM (Black)
Rear case
Front case
B. When the cable is along the wall:
●
●
Screws
CAUTION
Putty
Trap
Putty
Trap
- (05 - 10) -
Mount the rear case on the wall.
Cut off a hole for cabling in the front case.
Cut off
Front case
Putty
Trap
5. CONTROL SYSTEM