Using The Wps Button - Ricoh SP 220SNw User Manual

11. Configuring Network Settings Using OS X
4. If you are requested to enter a password, enter the password using the number
keys, and then press the [OK] key.
A password for accessing the [Network Settings] menu can be specified in [Admin. Tools
Lock] under [Admin. Tools] menu.
5. Press the [ ] or [ ] key to select [Wi-Fi], and then press the [OK] key.
6. Select [Wi-Fi Enable], and then press the [OK] key.
7. Press the [ ] or [ ] key to select [Enable], and then press the [OK] key.
8. Press the [User Tools] key to return to the Initial screen.
9. Wait until the machine restarts.
10. Press the [User Tools] key.
11. Press the [ ] or [ ] key to select [Wi-Fi Setup Wizard], and then press the [OK] key.
12. If you are requested to enter a password, enter the password using the number
keys, and then press the [OK] key.
A password for accessing the [Wi-Fi Setup Wizard] menu can be specified in [Admin. Tools
Lock] under [Admin. Tools] menu.
13. Press the [ ] or [ ] key to select SSID of the router (access point) from the searched
SSID list, and then press the [OK] key.
14. Enter the encryption key using the number keys, and then press the [OK] key.
As the passphrase, you can enter either 8 to 63 ASCII characters (0x20-0x7e) or 64
hexadecimal digits (0-9, A-F, a-f).
15. Press the [OK] key.
16. Check the result.
• Connection has succeeded:
Configuring the Wi-Fi settings is complete.
• Connection has failed:
Check the configuration for the router (access point), and then try the connection again.

Using the WPS Button

A router (access point) is needed to set up a connection.
Before doing the following procedure, install the printer driver according to the procedure on page 278
"Installing the Printer Driver".
Make sure the Ethernet cable is not connected to the machine.
1. Check that the router (access point) is working correctly.
280