Easy Setup Using The Wps Button; Easy Setup Using A Pin Code - Ricoh P C300W Setup Manual

Easy Setup Using the WPS Button

● Make sure the Ethernet cable is not connected to the
machine.
● In Steps 10 to 12, configure each setting within two
minutes.
● The following item is necessary to set up a wireless
connection.
● Router (access point)
1. Check that the router (access point) is working correctly.
2. Press the [ ] or [ ] key to select [Wired (Ethernet)], and
then the [OK] key.
Network Wizard 1 2
Wired (Ethernet)
Wireless (Wi-Fi)
3. Press the [ ] or [ ] key to select [Quit Setup], and then the
[OK] key.
Network Wizard
4 4
IPv4 Configuration
IPv6 Configuration
Quit Setup
4. Press the [Menu] key.
5. Press the [ ] or [ ] key to select [Network Settings], and
then press the [OK] key.
Settings
6 8
Wi-Fi Setup Wizard
Network Settings
Print List/Report
6. Press the [ ] or [ ] key to select [Wireless (Wi-Fi)], and
then press the [OK] key.
Network Settings
1 5
Wired (Ethernet)
Wireless (Wi-Fi)
IPv4 Configuration
7. Press the [ ] or [ ] key to select [WPS], and then press the
[OK] key.
6 9
Wireless (Wi-Fi)
Current Connection
Input SSID
WPS
8. Press the [ ] or [ ] key to select [PBC], and then press the
[OK] key.
WPS Type
1 2
PBC
PIN
9. Press the [ ] or [ ] key to select [Yes], and then press the
[OK] key.
PBC
WPS PBC Connect ?
Yes No
DYG081
ECB240
ECB202
ECB206
ECB207
ECB215
DSG092
ECB216
10. After "Connecting..." appears, press the WPS button on the
router (access point) within two minutes.
WPS
• For details about how to use the WPS button, refer to the manuals for
the router (access point).
11. Check the result.
Connection has succeeded:
PBC
Connection to AP
has Succeeded
• Press the [OK] key to return to the screen displayed in Step 6,
and then press the [Menu] key to return to the initial screen.
Connection has failed:
PBC
Connection to AP
has Failed
• Press the [OK] key to return to the screen displayed in Step 6.
Check the configuration for the router (access point), then try
the connection again.
12. Configuring the Wi-Fi settings is complete.
To use the printer driver, install the printer driver
according to the procedure on page 10 "3. Installing
the Printer Driver".

Easy Setup Using a PIN Code

● Make sure the Ethernet cable is not connected to the
machine.
● In Steps 11 to 13, configure each setting within two
minutes.
● To establish a connection using the PIN code, use a
computer that is connected to the router (access point).
● The following item is necessary to set up a wireless
connection.
● Router (access point)
1. Check that the router (access point) is working correctly.
2. Open the PIN code configuration window (web page) for the
router (access point) on your computer.
3. Press the [ ] or [ ] key to select [Wired (Ethernet)], and
then the [OK] key.
Network Wizard
1 2
Wired (Ethernet)
Wireless (Wi-Fi)
CHV607
EXIT
ECB227
EXIT
ECB228
DYG081
7