ABB REG670 Technical Manual page 1233

1MRK502052-UEN B
Technical manual
In figure 569 below the content of display is shown for a REX060 with one SIM and
one RIM module. Row 1 contains mains frequency information. Row 2-3 contains
stator information and row 4-5 rotor. Column 1 (empty) gives status, column 2 and 3
are informative and column 4 contains variables, settable by the keypad.
Column
1
Row
1
2
3
4
5
IEC10000334 V1 EN
Figure 569: Normal display content
When the injection unit REX060 is energized, the ABB logotype is shown followed
by current REX060 revision status. When the start up sequence is completed, the main
menu (normal display content) is shown. The duration of the start up sequence is a few
seconds.
LCD backlight is active during a period of 30 seconds after pressing any button.
Backlight activation by pressing a button will not cause any normal button action.
Column 1 is a status column (empty in the above picture), where the following
symbols are displayed when applicable:
Injection equipment hardware
2
System
f
STATOR
f
UmaxEF
ROTOR
f
Gain
IEC10000334-1-en.vsd
Section 22
3
4
[Hz] : 50
[Hz] : 087
[V] : 120
[Hz] :
113
4
1227