ABB REG670 Technical Manual page 1230

Section 22
Injection equipment hardware
1224
217 [8,54]
84 [3,3]
Ø 5,5 [0,22]
IEC11000037 V2 EN
Figure 565: Measure and drilling plan
REX061 shall be mounted close to the generator in order to limit the exposure of the
field circuit. Alternatively it can be located in the excitation cubicle.
The surface of REX061 unit may be temporarily very hot due to heat
dissipation, up to about 50° C above the ambient temperature. It must
be installed to get a open air convection and prevent contact with
combustible material to the surface.
84 [3,3]
1MRK502052-UEN B
155 [6,1]
2 [0,079]
IEC11000037-2-en.vsd
Technical manual