Power Troubleshooting - WaterLogic CUBE FIREWALL Manual

POWER TROUBLESHOOTING INDEX
1. No Power
Bypassing the Cover Pin Instruction is included in this Troubleshooting section.
No Power
Solution
Verify the building electrical supply to the CUBE is on and that the power cord is plugged in.
Verify the Red Power switch at the rear of the CUBE is on. I=ON
Test the CUBE's fuse.
Verify the Top Cover Isolation Switch is being activated by the top cover being locked in place
correctly. See Bypassing Cover Pin in this troubleshooting section.
Start normal fault finding procedures
CUBE Manual Page 68 - Revision: 5-24-2017