Programming - Filter Replacement Timing - WaterLogic CUBE FIREWALL Manual

PROGRAMMING: DIP SET-UP FILTER REPLACEMENT TIMING
Filters should be configured to optimize your system. Filters need to be configured and specified to do
the job given the local water conditions, usage, maintenance schedule, and placement restrictions.
In order for our filters to perform as represented and to provide the best quality water possible, it is
essential that filters be replaced periodically. The frequency of filter changes depends on your water
quality and your water usage. For example, if there is a lot of sediment and/or particles in your water,
then you will have to change your filters more frequently than a location with little to no sediment. Be
sure to replace your filters whenever you notice a decline in the performance, whether it is a drop-in flow
rate and/or pressure or an unusual taste in the water.
CUBE Main PCB - DIP Switch 1
A combination of switches 2 and 3
• 3 Months
• 6 months
• 12 months
• None
CUBE Manual Page 38 - Revision: 5-24-2017