WaterLogic CUBE FIREWALL Manual page 27

12. Fit the filter assembly into the machine:
a. Insert the filter assembly
back into its cradle,
aligning the two male
spigots with the female
holes in the cradle
13. Replace Top Cover and Screws.
14. Turn on the Water Supply.
15. Turn on Red Power Switch I=ON
*Do not turn on Green Heater / Compressor Switch until instructed to do so.
16. Select Cold Water and dispense until water flows clear. This step flushes the
carbon fines from the filter.
17. Reset filter service timer. Reset by selecting the hot and cold icons simultaneously and holding
them for 10 seconds. The unit will beep and the filter service indicator light will turn off once
reset is complete.
18. Turn on Green Heater / Compressor Switch. I=ON
CUBE Manual
b. Push it firmly until the
filter sits snugly and is
flush with the cradle
top surface
c. Lock the filter by
closing the locking
lever until it 'clicks'
into place
Page 27 - Revision: 5-24-2017