Table of Contents
Advertisement
7.
Reconnect the power lead into the back of the machine
and plug in to power source.
8.
Turn on Red Power Switch to the On Position I = On
9.
Visually verify that the UV Lamp is working correctly by
checking the PCB LED. There should be no warning icons
flashing.
Note: UV Lamp Sensor is temperature sensitive. During extended periods of use, especially
when filling or draining the unit, when water is not being dispensed UV Lamp Sensor can
overheat, initiating a UV Fault. If this occurs, turn off the unit for 5 minutes and allow sensor
to cool before resuming operation.
CUBE Manual
Page 29 - Revision: 5-24-2017
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the CUBE FIREWALL and is the answer not in the manual?
Questions and answers