WaterLogic CUBE FIREWALL Manual page 57

6. Place a container in the dispense area for flushing process. The filter will now
need to be flushed.
7. Turn off both the Red Power and the Green Heater / Compressor Switch's.
O=OFF
NOTE: Switches have internal LED that illuminates when placed in I=ON
position.
CAUTION! NEVER TURN ON HEATER BEFORE FILLING HOT TANK.
Green Compressor/Heater Switch must be in the O=OFF position while the Hot Tank is empty.
Damage could occur within one minute and the overload (high limit) will require manual reset if
heater is turned on with an empty Hot Tank.
8. Select the Ambient Water Icon followed by the main dispensing button, dispense 10 liters of water.
This will remove excess carbon fines and sufficiently generate the filter.
9. Prime the Hot Tank. Holding a container under the dispensing faucet, press the hot button until it
lights up. While the hot water icon is lit, select and hold the central dispense button until a
continuous flow of water is obtained (this could take 2 to 4 minutes). Once a continuous flow is
obtained, flush 5 liters of water by continuing to hold the hot button. Hot Tank is now full.
10. Prime the Cold Circuit. Holding a container under the dispensing faucet, Select and hold the cold-
water icon until it lights up. While the cold-water icon is lit, select the central dispense button to
start filling the cold tank with water. After one minute, the machine will automatically un-select the
central dispense button. Repeat selection of the central dispense button until the cold tank has filled
and water is coming out of the faucet (this could take 2 to 4 minutes), press and hold the main
dispensing button until a continuous flow of water is obtained. Once a continuous flow is obtained,
release the dispensing button. Cold tanks are now full.
11. Prime the Ambient Circuit. Holding a container under the dispensing faucet, Select and hold the
Ambient water icon until it lights up. While the Ambient water icon is lit, select the central dispense
button to start filling the Ambient line with water (this could take 10 – 20 seconds). Continue to
dispense 15-20 fluid ounces more of water through the ambient option.
12. Turn on the Green Heater/ Compressor switch at the rear of the machine.
CUBE Manual Page 57 - Revision: 5-24-2017