Operating Instructions - WaterLogic CUBE FIREWALL Manual

The above picture shows front LCD display and control panel for the Waterlogic CUBE Water Treatment
System.
Button
Hold for 3 seconds
Hold until
Extra Hot Selection button
stops flashing – indicates the
temperature has been reached.
CUBE Manual

OPERATING INSTRUCTIONS

Select Cold Water Selection + Press and Hold Dispensing Button to start
dispensing until desired fill.
Select Ambient Water Selection + Press and Hold Dispensing Button to
start dispensing until desired fill.
Press and Hold Hot Water Selection for 3 seconds, until the Hot Water
Icon is illuminated. Press + Press and Hold Dispensing Button until
desired fill. The delay is a safety feature that prevents hot water from
being accidently dispensed.
Press and Hold Extra Hot Water Selection. The Extra Hot Selection
Button will flash red to indicate the water is heating. When the red
flashing icon turns off, this indicates that the water is to the
temperature.
Press the Hot Water Selection Button + Press and Hold Dispensing Button
until desired fill.
WARNING! Unit produces Very Hot Water up to 203°F. Water above
125°F can cause severe burns or scalding. Keep unauthorized people
and children away from the unit to avoid accidental dispensing of
hot water. Children should not use without supervision.
Operational Use
Page 10 - Revision: 5-24-2017