Appendix A Watlow Ez-Zone ® Pm6 Series; Controller Description; Hardware Setup; Display & Keys - Thermo Scientific SOLA II User Manual

Appendix A
Watlow EZ-ZONE PM6 Series
®
Controller
®
The Watlow EZ-ZONE PM6 series controller is used to control the
temperatures of the pyrolyzer furnace and the analyzer oven. The controller
Description
provides a signal output if the zone temperature is outside a specified range.
This appendix provides basic operating instructions and default configuration
settings. For complete operating information and troubleshooting, refer to the
EZ-ZONE PM PID Controller user's manual.

Hardware Setup

The EZ-ZONE PM6 is wired at the factory according to your application. No
other hardware settings are required.
Display & Keys
The display and keys on the EZ-ZONE PM6 are shown below and described in
the table that follows.
Figure A–1. EZ-ZONE PM6 series controller
Thermo Fisher Scientific SOLA II User Guide A-1