Clearing Cmos - Advantech WP-5530-PD10 User Manual

Clearing CMOS

The WP-5530's configuration (CMOS) may occasionally be corrupted. If it is, it will be necessary to clear
the CMOS memory using jumper CLRCMOS1. Please refer to Chapter 4 for the exact CLRCMOS1 pin
positions.
1. Turn off the system power properly through the operating system, then turn off any external
devices.
2. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
NOTE:
3. Remove the system box and box cover.
4. Locate the JP1 jumper box on the main board IMB-151 and IMB-183.
5. Remove the jumper shunt from pins 2-3 and place over pins 1-2.
6. Wait 60 seconds to allow the CMOS to clear, then remove the jumper shunt and place it b ack in its
original position over pins 1-2.
7. Replace the box cover and system box into the system.
Regardless of the power-on state, voltage is always present on the main board as
long as the system is plugged into an active AC outlet. The power cord must be
disconnected from the power source before clearing the CMOS.
All LEDs on the board should be OFF. Failure to ensure there is no power in the
system may damage the main board. You must disconnect the power cord to
avoid damage to the internal components of the system.
12