Table of Contents
Advertisement
2.5.8
Reading barcodes, 2D CMOS version
The 2D CMOS version can read both 1D and 2D bar codes. To use the
scanning function, complete the following steps:
1.
If you have not already done so, remove the protective plastic film
before using devices equipped with a 2D CMOS bar code reader.
2.
Select Start > Setting > Control Panel > 2DBarcode; complete all
configurations following all description of Appendix A. 2D Bar-
code Setting.
3.
Run the WordPad software program.
4.
Press one of the three bar code reader trigger buttons.
5.
Aim the scanning beam at the center of bar code. To assists in aim-
ing, there are 4 green aiming light spots. The bar code should be
between the outside 2 green spots. The scanner is in focus in case
the center 2 green spots joins into 1 spot.
MARS-1030F User Manual
46
Advertisement
Table of Contents
