Terminal Hardware; Which Plugs Go Where - PAX S300 Combo User Manual

CONTACT
For EFTPOS terminal enquiries, issues or support contact Smartpay Technical Helpdesk on
0800 476 278 or email customer.service@smartpay.co.nz

TERMINAL HARDWARE

Smartpay two-piece countertop EFTPOS is a Pax S300 customer facing touchscreen PINpad plugged
into a merchant facing Pax S80c or Pax S800 base unit.

Which Plugs Go Where?

On the back of your S80/c and S800 EFTPOS terminals there are ports available for plugging in
the required cables. These ports are labelled but can be difficult to read. For ease of use we have
included diagrams and descriptions.
LAN/
LINE
POWER
RS232A
PINPAD
Smartpay User Guide
An Ethernet cable should be plugged in here to connect the terminal to a
Broadband/Fibre Internet connection.
If you use a dial-up Internet connection the phone cable should be plugged in here.
The power cable supplied with your terminal plugs in here. Plug the other end
into your wall socket or a power strip.
If you are using a Keylink interface to your ECR/POS system connect the
Keylink cable or accessory supplied here.
Plug the S300 PINpad in here for two-piece EFTPOS setup.
NOTE: When the S300 is plugged into an S800 you will need to pull the power
cable or turn S800 off at the wall to manually power off the S300.
Pax S300 Combo
(with S800 or S80/c)
3